Prg AutoPar User Manual 2.1 Uživatelský manuál stáhnout pdf (Strana 16)

8 AUTOPAR

WASH LUMINAIRE USER MANUAL

POWER AND DATA CABLING REQUIREMENTS

Power

The AutoPar Wash Luminaire requires standard AC power distribution from 100-240 VAC, 50/60 Hz, 10 Amps

maximum. The upper enclosure provides a Neutrik® connector for power input. (Power cable not supplied.)

Figure 2-1: Power Input Connector

Data

The AutoPar Luminaire is equipped with two, 5-pin XLR connectors for DATA IN and DATA THRU (out) applications.

DATA IN requires a 5-pin, female XLR connector and DATA THRU requires a 5-pin, male XLR connector. When

purchasing or constructing data cables, it is important that not only the correct cable type be used, but also quality

cable to ensure a reliable DMX512 system. Your cabling should meet the following USITT DMX specification

requirements:

+ Suitable for use with EIA485 (RS485) operation at 250k baud.

+ Characteristic impedance 85-150 ohms, nominally 120 ohms.

+ Low capacitance.

+ Two twisted pairs.

+ Foil and braid shielded.

+ 24 AWG minimum gauge for runs up to 1000 feet (300m).

+ 22 AWG minimum gauge for runs up to 1640 feet (500m).

Note: Microphone type cables and other general purpose, two-core audio or signal cables are not suitable for use

with DMX512.

Neutrik AC

Power Connector

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 47 48

Žádné komentáře

Prg AutoPar User Manual 2.1 Uživatelský manuál Strana 16