Prg AutoPar User Manual 2.1 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Osvětlení Prg AutoPar User Manual 2.1. PRG AutoPar User Manual 2.1 User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk

Shrnutí obsahu

Strany 1 - WASH LUMINAIRE

SOFTWARE VERSION 2.1WWW.PRG.COMAUTOPAR® WASH LUMINAIREUSER MANUAL

Strany 2

2 AUTOPAR® WASH LUMINAIRE USER MANUALCustomer ServiceFor technical assistance, contact the PRG International Service Center or contact your nearest PR

Strany 3 - FOREWORD

1.DESCRIPTIONThis chapter contains descriptions of luminaire features, components, and accessories.+FEATURES+ COMPONENTS

Strany 4 - II AUTOPAR

4 AUTOPAR® WASH LUMINAIRE USER MANUALFEATURESOverviewThe AutoPar Wash Luminaire from PRG Lighting is a compact, lightweight fixture which incorporates

Strany 5 - Notes de sécurité

AUTOPAR® WASH LUMINAIRE USER MANUAL 5COMPONENTSIncluded ItemsThe following illustration shows all items included with the luminaire:Figure 1-1: AutoP

Strany 6 - Revision History

6 AUTOPAR® WASH LUMINAIRE USER MANUALMajor Components and ControlsThe following illustration shows the external luminaire components and controls.Figu

Strany 7 - TABLE OF CONTENTS

2.INSTALLATIONThis chapter contains instructions for installing the luminaire. It includes connecting power and data, along with instructions for pow

Strany 8 - VI AUTOPAR

8 AUTOPAR® WASH LUMINAIRE USER MANUALPOWER AND DATA CABLING REQUIREMENTSPowerThe AutoPar Wash Luminaire requires standard AC power distribution from 1

Strany 9 - INTRODUCTION

AUTOPAR® WASH LUMINAIRE USER MANUAL 9The XLR 5-pin connectors should be wired as follows:Note: Refer to the USITT Recommended Practice for DMX512 gui

Strany 10 - Customer Service

10 AUTOPAR® WASH LUMINAIRE USER MANUALMale Termination ConnectorA male XLR termination connector is required at the last luminaire (or "far end o

Strany 11 - DESCRIPTION

AUTOPAR® WASH LUMINAIRE USER MANUAL 11INSTALLATION PROCEDUREHanging the LuminaireThe AutoPar wash luminaire can be hung horizontally or vertically fro

Strany 12 - FEATURES

AutoPar®, Bad Boy®, PRG Series 400®, Mbox Extreme®, V676®, Virtuoso®, Virtuoso® DX, Virtuoso® DX2, and VL6C+™are trademarks of Production Resource Gr

Strany 13 - COMPONENTS

12 AUTOPAR® WASH LUMINAIRE USER MANUALInstalling in Truss:Step 1. Attach hardware and loop safety cable through mounting bracket slot (Figure 2-2).Ste

Strany 14 - Major Components and Controls

AUTOPAR® WASH LUMINAIRE USER MANUAL 13Floor Mounting the LuminaireThe luminaire enclosure is sufficient to stabilize the luminaire in a floor installa

Strany 15 - INSTALLATION

14 AUTOPAR® WASH LUMINAIRE USER MANUALPOWER UP PROCEDUREPowering Up the LuminaireWhen AC power is applied, the luminaire will begin a calibration sequ

Strany 16 - WASH LUMINAIRE USER MANUAL

AUTOPAR® WASH LUMINAIRE USER MANUAL 15Programming a Starting AddressThe address setting for DMX512 systems is programmed at the Menu Display (refer to

Strany 17 - WASH LUMINAIRE USER MANUAL 9

16 AUTOPAR® WASH LUMINAIRE USER MANUALNotes

Strany 18 - Male Termination Connector

3.OPERATIONThis chapter contains instructions for using the Menu Display system and controlling the luminaire by DMX512.+MENU SYSTEM+ DMX512 OPERATION

Strany 19 - INSTALLATION PROCEDURE

18 AUTOPAR® WASH LUMINAIRE USER MANUALMENU SYSTEMOverviewThe menu system is a programmable set of commands used to configure, address, and report stat

Strany 20 - Recommended for all hanging

AUTOPAR® WASH LUMINAIRE USER MANUAL 19Menu FunctionsThe following is a graphic representation of the menu system. Fixture, Dmx, Lamp and Test are top

Strany 21 - Connecting Data and Power

20 AUTOPAR® WASH LUMINAIRE USER MANUALDMX512 OPERATIONChannel MappingThese tables assume a DMX512 start address of 1. When a different starting addres

Strany 22 - POWER UP PROCEDURE

AUTOPAR® WASH LUMINAIRE USER MANUAL 21Control Channel FunctionsControl channel functions allow special actions such as reset, douse and start. These m

Strany 23 - Setting DMX512 Address

AUTOPAR® WASH LUMINAIRE USER MANUAL IFOREWORDCompliance NoticeThis device complies with Part 15 of the FCC rules. Operation is subject to the followin

Strany 24 - 16 AUTOPAR

22 AUTOPAR® WASH LUMINAIRE USER MANUALLUMINAIRE TIMINGTiming Channel InformationTiming channel control allows for smoother transition and movement of

Strany 25 - OPERATION

AUTOPAR® WASH LUMINAIRE USER MANUAL 23Timing channels can be set in either % or 0-255 (DMX) modes, with the following values assigned:Table 3-1: DMX M

Strany 26 - MENU SYSTEM

24 AUTOPAR® WASH LUMINAIRE USER MANUAL81 2232 82 2283 2333 84 2385 2386 2434 87 2488 2535 89 2590 2591 2636 92 2693 2737 94 2795 2796 2838 97 2898 293

Strany 27 - Menu Functions

AUTOPAR® WASH LUMINAIRE USER MANUAL 25165 5565 166 55167 5666 168 56169 56170 5767 171 57172 5868 173 58174 58175 5969 176 59177 59178 6070 179 60180

Strany 28 - DMX512 OPERATION

26 AUTOPAR® WASH LUMINAIRE USER MANUAL249 30098 250 300251 31099 252 310253 310254 310100 255 Follows Cue DataTable 3-1: DMX Mapping (Continued)% Val

Strany 29 - Control Channel Functions

4.TROUBLESHOOTING AND MAINTENANCEThis chapter provides a basic troubleshooting guide, along with procedures for extended care of the luminaire.+TROUBL

Strany 30 - LUMINAIRE TIMING

28 AUTOPAR® WASH LUMINAIRE USER MANUALTROUBLESHOOTINGError MessagesAfter calibration, the Menu Display will cycle through any applicable error message

Strany 31 - Table 3-1: DMX Mapping

AUTOPAR® WASH LUMINAIRE USER MANUAL 29Troubleshooting GuideThe following table provides a list of common failures and possible solutions.Symptom Messa

Strany 32 - 24 AUTOPAR

30 AUTOPAR® WASH LUMINAIRE USER MANUALROUTINE MAINTENANCEReplacing LampParts:71.2566.0700.0 LAMP, MSR 700WTools:#2 Phillips ScrewdriverWARNING: Remov

Strany 33

AUTOPAR® WASH LUMINAIRE USER MANUAL 31Aligning LampAfter a new lamp is installed, it will be necessary to align the lamp to optimize the beam. Screws

Strany 34 - 26 AUTOPAR

II AUTOPAR® WASH LUMINAIRE USER MANUALWARNING: INSTRUCTIONS FOR PROTECTION AGAINST INJURY TO PERSONS1) Exterior surfaces of the luminaire will be hot

Strany 35 - ROUTINE MAINTENANCE

32 AUTOPAR® WASH LUMINAIRE USER MANUALReplacing Front LensThe luminaire includes four different front lens which can be swapped as needed.Parts:LENS,

Strany 36

AUTOPAR® WASH LUMINAIRE USER MANUAL 33Installing a Color GelColor gels can be installed in the gel frame located at the front of the head assembly.Too

Strany 37 - Troubleshooting Guide

34 AUTOPAR® WASH LUMINAIRE USER MANUALCleaning the LuminaireTools:Window cleaner (commercial grade)Clean, lint-free clothVacuum cleaner with brush noz

Strany 38

A. TECHNICAL SPECIFICATIONS

Strany 39 - Aligning Lamp

36 AUTOPAR® WASH LUMINAIRE USER MANUALAutoPar Wash LuminaireDescriptionSOURCE: Philips MSR700 1CT 700W arc lampColor Temp: 5600°KCRI: 85BALLAST: Integ

Strany 40 - Replacing Front Lens

AUTOPAR® WASH LUMINAIRE USER MANUAL 37Photometric DataAutoPar Luminaire with MSR700 Lamp* Multiply throw distance by Tn to determine coverage.**To cal

Strany 41 - Installing a Color Gel

38 AUTOPAR® WASH LUMINAIRE USER MANUALNotes

Strany 42 - Cleaning the Luminaire

AutoPar® Wash Luminaire User ManualVersion as of: November 8, 2010PRG part number: 02.9802.0001.21

Strany 43 - TECHNICAL SPECIFICATIONS

Production Resource GroupDallas Office8617 Ambassador Row, Suite 120Dallas, Texas 75247www.prg.com

Strany 44 - AutoPar Wash Luminaire

AUTOPAR® WASH LUMINAIRE USER MANUAL IIINotes de sécuritéAvant de procéder à l’installation des produits décrits dans ce guide et de les mettre en marc

Strany 45 - Photometric Data

IV AUTOPAR® WASH LUMINAIRE USER MANUALRevision HistoryThis manual has been revised as follows:Version Release Date NotesBASIC February 8, 2006 Softwar

Strany 46 - 38 AUTOPAR

AUTOPAR® WASH LUMINAIRE USER MANUAL VTABLE OF CONTENTSIntroductionAbout This Manual...

Strany 47

VI AUTOPAR® WASH LUMINAIRE USER MANUALAppendix A. Technical SpecificationsAutoPar Wash Luminaire .....

Strany 48 - Dallas, Texas 75247

AUTOPAR® WASH LUMINAIRE USER MANUAL 1INTRODUCTIONAbout This ManualThis manual provides necessary information regarding product safety, installation, a

Komentáře k této Příručce

Žádné komentáře